Call us at 855.877.3630

W.R. MEADOWS P/G PRIMER QUART (1A+1B)

Hazardous Material - Freight Shipping Only 

Be the first to review this product

Availability: In stock

$19.92
 

Details

W.R. Meadows P/G Primer is a solvent-based, two-component primer system for use with DECK-O-SEAL® line.

It aids in the adhesion of joint sealants to the interfaces of expansion joints in masonry, swimming pool decks, concrete, or wood.

Packaging

  • 1 Quart (.95 Liter) Containers (3/Carton)

Coverage

  • Depending on the porosity of the surface and joint dimensions, one quart (.95 L) of P/G PRIMER will be sufficient for 5 – 7 gallons (18.9 – 26.5 L) of sealant.

Shelf Life

  • When stored indoors in original, unopened containers at temperatures between 40° – 90° F (4° – 32° C), optimum performance and best use is obtained within two years of date of manufacture.

Application

Surface Preparation

Prior to application of P/G PRIMER, joint surfaces must be structurally sound, clean, dry, and free of oil, grease, dirt, and loose particles. Remove all curing compounds and form release agents from joint surfaces. Joints must be clean of bituminous materials and bituminous-impregnated joint fillers. Control depth of sealant using KOOL-ROD™ backer rod from W. R. MEADOWS. All joints subject to total immersion in water MUST be primed with P/G PRIMER. Control depth of sealant subject to submersion with SELF-EXPANDING CORK EXPANSION JOINT or CORK EXPANSION JOINT from W. R. MEADOWS or suitable expansion joint to support the weight joint sealant is subject to. It is recommended an engineer be consulted for calculation. Note: Submerged joints should only be sealed by a professional and/or trained contractor.

Mixing

Components are pre-measured to exact quantities; mix all material in both containers. Pour part A into part B and mix thoroughly with a clean wooden or metal paddle for approximately 3 – 4 minutes. Scrape container sides and bottom for complete integration. After mixing, work life is approximately five hours at 70° F (21.1°) (less at higher temperatures).

Application Method

Apply P/G PRIMER to properly prepared joint surfaces by brush, depositing a light, continuous film. Normally one coat is sufficient; however, two coats should be applied to very soft, porous surfaces. Do not over-apply. Use caution when applying in joints with backer rods. Over-application onto backer rod can cause it to shrink and dissolve. PRIMER MUST BE TACKY TO THE TOUCH AND NOT ALLOWED TO DRY WHEN APPLYING SEALANT TO JOINT. P/G PRIMER is non-staining, but should not be applied to exposed surfaces, as discoloration may become apparent. Tape joint edges if necessary.

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Write Your Own Review

You're reviewing: W.R. MEADOWS P/G PRIMER QUART (1A+1B)

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars
Rating