Call us at 855.877.3630

CARLISLE CCW-702 PRIMER

Hazardous Material - Freight Shipping Only

Be the first to review this product

Availability: In stock

From: $186.42

* Required Fields

From: $186.42
 

Details

Carlisle 702 is a quick-drying, solvent-based, high-tack adhesive specifi cally designed to promote maximum adhesion of CCW Membrane Waterproofing products.

Apply by medium (3/8" for best results) nap roller or brush in an even film at 300 to 350 square feet per gallon. Caution must be taken not to apply excess contact adhesive which could cause longer drying times. Allow adhesive to dry for 20 minutes minimum at 75°F. Drying times may vary at lower temperatures. Porous substrates require additional material, reducing the coverage rates for proper adhesion. Adhesive has a satisfactory cure when surface is tacky, but will not transfer when touched. Apply only in areas to be waterproofed the same day. Reapply if area becomes dirty or wet. When used in adverse climactic conditions (i.e. humid, cool, etc.) or
on a porous substrate, additional time will be required.

All fluid-applied product application rates are based on theoretical coverage relative to the percentage of solids in the material. These are minimum application rates to achieve the required dry film thickness for the system and do not account for substrate condition or porosity. A thicker application of the product may be necessary to achieve the required dry fi lm thickness for system relative to the substrate. Apply to any surface the same day of application of membrane.

Surface Preparation for Gypsum-Sheathing with Glass-Mat Facers:
When installing CCW sheet membranes and sheet flashings over gypsheathing with glass-mat facers, coverage rates for contact adhesives and primers will depend on the porosity and texture of the sheathing and will vary substantially by gypsum-sheathing brand and manufacturer. To achieve consistent contact adhesive and/or primer coverage with adequate tack, it may be necessary to decrease the coverage rate (i.e.Increase the amount applied) of the contact adhesive and/or primer and/or the application of multiple coats. CCW Contact adhesives and primers shall be allowed to dry completely (lower temperatures will extend drying time) before additional coats are applied or membranes installed. Caution should be taken as contact adhesives and/or primers applied to gyp-sheathings with glass-mat facers will take longer to dry than other substrates. Multiple adhesion tests should be performed randomly to verify proper application of primer and ensure a successful application.

Additional Documents
Carlisle CCW-702 Primer

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Write Your Own Review

You're reviewing: CARLISLE CCW-702 PRIMER

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars
Rating