Carlisle Sure-Seal Termination Bar - Extruded aluminum bar designed for securing and sealing flashing terminations in accordance with current Carlisle Specifications
Carlisle Sure-Seal Termination Bar - Extruded aluminum bar can be installed by peeling back ���ashing material approximately 1"" (25 mm). Then apply Water Cut-Off Mastic between substrate and ���ashing(approximately 10' (3 m) per tube), and install termination bar by fastening 12"" (300 mm) o.c. maximum with a fastener compatible with the substrate to achieve constant compression of Water Cut-Off Mastic. Start fastening at one end of the bar and proceed to the next slot (12"" max.) to eliminate bowing caused by improper installation. Trim the top edge of ��� ashing ���ush with top of the termination bar. Now, apply Lap Sealant to the top edge of the bar and feather.
- Corrosion resistant 6063-T6 extruded aluminum
- Pre-Punched 6"" (150 mm) o.c. and 1"" (25 mm) from each end
- Sealant ledge to hold the Lap Sealant and provide stability
- Serrated back provides increased surface area contact with membrane to compress the Water Cut-Off Mastic.
Carlisle Sure-Seal Termination Bar should only be applied on a hard, smooth surface only; not for use on wood, water Cut-Off Mastic must be held under constant compression. Do not wrap compression termination around corners. When ��eld cutting is necessary, remove any burrs or sharp edges from the bar. Allow ¼"" (6 mm) minimum to ½"" (12 mm) maximum spacing between bars.
