CARLISLE CCW-715

5gl pail | 45 units perpallet

Be the first to review this product

Availability: Out of stock

 

Details

CCW-715 adhesive is designed to allow adhesion of CCW Sheet Membranes to damp or partially cured concrete surfaces.


Carlisle CCW-715 Product Data Sheet

 

This allows installation of membrane as soon as forms are removed. Do not apply where visible water is present as trapped water may cause blistering. Keep direct sunlight off membrane and backfi ll immediately.

 

Installation
Apply by medium nap roller (3⁄8" nap for best results) or brush in an even fi lm at 300 to 350 square feet per gallon. Caution must be taken not to apply excess contact adhesive which could cause longer drying times. Allow adhesive to dry for 30 minutes minimum at 70°F. Adhesive has a satisfactory cure when surface is tacky, but will not transfer when touched. Apply only on areas to be waterproofed and backfi lled the same day. Reapply if area becomes dirty or wet. 

 

All fluid-applied product application rates are based on theoretical coverage relative to the percentage of solids in the material. These are minimum application rates to achieve the required dry film thickness for the system and do not account for substrate condition or porosity. A thicker application of the product may be necessary to achieve the required dry film thickness for system relative to the substrate.


Surface Preparation for Gypsum-Sheathing with Glass-Mat Facers
When installing CCW sheet membranes and sheet fl ashings over gypsheathing with glass-mat facers, coverage rates for contact adhesives and primers will depend on the porosity and texture of the sheathing and will vary substantially by gypsum-sheathing brand and manufacturer. To achieve consistent contact adhesive and/or primer coverage with adequate tack, it may be necessary to decrease the coverage rate (i.e.Increase the amount applied) of the contact adhesive and/or primer and/ or the application of multiple coats. CCW Contact adhesives and primers shall be allowed to dry completely (lower temperatures will extend drying time) before additional coats are applied or membranes installed.Caution should be taken as contact adhesives and/or primers applied to gyp-sheathings with glass-mat facers will take longer to dry than other substrates. Multiple adhesion tests should be performed randomly to verify proper application of primer and ensure a successful application.

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Write Your Own Review

You're reviewing: CARLISLE CCW-715

How do you rate this product? *

  1 star 2 stars 3 stars 4 stars 5 stars
Rating